The fifth project that we had to do was to make a six sided container. We first had to make the plans cut on paper and then transfer them to AutoCAD. After we transfer them we cut them into wood and then assemble them to make our container.

The trick was that the container couldn't be a simple cube, it had to stand on only ONE side, which meant the other sides had to be uneven, and there only could be 3 gaps in the whole design.

In my opinion, this was the hardest project we had for the fact that I had to start over various reasons because I kept getting the cuts wrong and not all of the sides were uneven except one.

This was made by using AutoCAD.